Thinner gimp and boondoggle laces will yield more length in the final product. Using two different colors will be easier at first while you’re learning the crown sinnet method.
Do not cross the strands as you draw up the loops; just make sure they both loop over the finger that’s holding down the center.
Your two ends for the top strand should now be facing the same direction.
Make sure the strand you’re weaving isn’t the one you just weaved through a loop and draw it toward the center. Note that the loop your second top strand went under is the loop your first top strand went over.
If you’re using a thread-based material, such as craft lace, simply cut the ends close to the lanyard and burn them with a match or secure them with crazy glue. [1] X Research source If you’re using gimp or boondoggle material, you’ll need to do a finishing “stitch. " Loosen the loops of your last stitch a bit first. Then take one of your strands and pull it through the loop of the other strand of the same color, going under the same-color strand as well as the different-colored strand beneath it. Finally, pull your strand up through the center of the lanyard. Repeat this for all four strands, pulling each strand tight when they’re all through, and then trim the strands to your desired length.
You may now disregard the color-specific aspects of the process (which were included for clarity) because what matters is the position and sequence of the weaving.
For boondoggle, 3 to 4 yards is a good length for a beginner’s lanyard. [2] X Research source
Stop before you run out of material, as you will need to tie-off your end to secure your stitching. Do not twist your strands as you bend them around behind the others, otherwise it will disrupt the diamond pattern. [6] X Research source
